Hi all,
makes sense to use UCCNC with UC400ETH under the control from Windows 10-64bit? My old PC has gone to nirvana and I need a new computer. The old pc ran under Windows 7-32bit without any problems. But W7 is an old system. Are any problems to be expected or known?
Thanks for infos.
Cheers
Peter
UCCNC and Win10
5 posts
• Page 1 of 1
UCCNC and Win10
by CADdy » Sat Mar 02, 2019 6:52 pm
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
Re: UCCNC and Win10
by cncdrive » Sat Mar 02, 2019 7:10 pm
No problems with that.
All Win XP, 7, 8, 8.1 and 10 are supported, all 32 and 64 bits versions of them.
All Win XP, 7, 8, 8.1 and 10 are supported, all 32 and 64 bits versions of them.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: UCCNC and Win10
by ger21 » Sat Mar 02, 2019 7:36 pm
I've never run UCCNC on anything other than Windows 10.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: UCCNC and Win10
by CADdy » Sat Mar 02, 2019 8:23 pm
Hi Balazs, Hi Gerry,
thanks for your replies. I'm very proud to hear from the masters of UCCNC and the Screenset 2017
The combination from these two professional things is the best I ever used!
I start installing win10 immediately...
Cheers
Peter
thanks for your replies. I'm very proud to hear from the masters of UCCNC and the Screenset 2017
The combination from these two professional things is the best I ever used!
I start installing win10 immediately...
Cheers
Peter
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
5 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 18 guests