PC Crashed, UCCNC Won't Recognize My UC400ETH
3 posts
• Page 1 of 1
PC Crashed, UCCNC Won't Recognize My UC400ETH
by jtb223 » Mon Feb 04, 2019 9:06 pm
My PC crashed and I needed to reload Win10. I reloaded UCCNC but it won't recognize my UC400ETH. When I run UCCNC the blue LED blinks once but the software only allows me to enter the demo mode. Any suggestions?
- jtb223
- Posts: 25
- Joined: Fri Sep 09, 2016 1:23 am
Re: PC Crashed, UCCNC Won't Recognize My UC400ETH
by cncdrive » Mon Feb 04, 2019 10:04 pm
Setup the network IP as described in the UC400ETH manual.
The blue LED blinks once because the UC400ETH gets the broadcast message when the UCCNC explores all motion controllers connected to the PC.
The blue LED blinks once because the UC400ETH gets the broadcast message when the UCCNC explores all motion controllers connected to the PC.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: PC Crashed, UCCNC Won't Recognize My UC400ETH
by jtb223 » Tue Feb 05, 2019 1:05 am
Thanks. Back up and running.
- jtb223
- Posts: 25
- Joined: Fri Sep 09, 2016 1:23 am
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 5 guests