UC300 ETH - 5LPT - Bob advice
2 posts
• Page 1 of 1
UC300 ETH - 5LPT - Bob advice
by Robertspark » Sat Nov 19, 2016 4:19 pm
If I were thinking about a bob design for the uc300 - 5LPT, would it be recommended to use optoisolators for the step and direction signals to stepper drives or could direct connection from the outputs be done at 5v?
UCCNC Macro Manual v1.2113 - https://drive.google.com/drive/folders/ ... sp=sharing
- Robertspark
- Posts: 1892
- Joined: Sat Sep 03, 2016 4:27 pm
Re: UC300 ETH - 5LPT - Bob advice
by cncdrive » Sat Nov 19, 2016 6:24 pm
It depends on if the stepper drive has the optoisolators on the inputs.
Most stepper drives have that, so then the outputs of the UC300ETH-5LPT can be connected directly to drive the optocouplers.
Most stepper drives have that, so then the outputs of the UC300ETH-5LPT can be connected directly to drive the optocouplers.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests