MODBUSEZ Plugin

[mrping]

it is version 49...

[mrping]

The modbusez was old though upgrading it now

[mrping]

Im running 49 version now with modbusez version 16. It is not saving my config, its reset every time I start UCCNC.

[mrping]

changed min RPM to like 6000 and it worked (my spindle is 200 - 6000 though).
But the same thing occurs, spindle starts, stops in the middle of loading and then starts spinning again. No commands works.
Maybe it uses other registers ?

[mrping]

spindle cw seems to be 0001
spindle ccw seems to be 0002
spindle off 0006

frequence is unknown

[Dan911]

mrping does this use a Modbus protocol for serial communication??? If not ModbusEZ isn't going to work out of the box. The manual gives no info.

Dan

[mrping]

Yes and CW, CCW, stop works with modbusez plugin.
its only the rpm left.

Can i read it out someway ?

[mrping]

See pic

[mrping]

.

[Dan911]

Yes with a Serial Monitor, you can try the free trial 1 here.>>> https://www.eltima.com/products/serial-port-monitor/

ModbusEZ divides you Max HZ with your max RPM and sends results in a high low byte in hex to register you input in settings.
For example with your settings, you set your RPM to 3000 it's going to send 25HZ (hex 00FA) or (09c4) depending on frequency resolution setting. Don't have time today but will take a better look at your manual tomorrow and see if I can help.

Dan