Toolpath Viewer - jog follow? Other options?

[ctbjdm]

Hi there,

New to UCCNC from an Ethernet Smooth Stepper (ESS) and Mach3. Really like it so far.

I have a couple problems/questions with the Toolpath Viewer:

1) Is there a Jog Follow option like from Mach3? I.e. the Toolpath Viewer automatically follows the tool location?
2) I use the mouse wheel to zoom in and out. Zooming in works fine / as expected. Zooming out however is weird - one wheel 'click' out and the image zooms WAY out (not one step like it does when I zoom in). I have tested the mouse wheel in other apps and it seems to work fine - one wheel 'click' moves both in and out as expected.

[cncdrive]

1.) On the left side of the toolpath there is an icon for jog-follow mode.
2.) The toolpath zooms the same amount in and out per mouse wheel tick. I've just tested it and it works fine here.

[ger21]

2.) The toolpath zooms the same amount in and out per mouse wheel tick. I've just tested it and it works fine here.

Was this changed at some point recently?
I recall always seeing something similar to what the OP mentioned, but I just checked, and it seems to work fine in 1.2106.

[cncdrive]

I don't remember now, but I have checked the current official release 1.2048 and the current test release 1.2106 and both work fine at me.

[dezsoe]

To zoom fine, press and hold middle button and move the mouse.

The zoom steps depend on the mouse and/or its driver. The worst case is a touch screen: scroll makes too large steps, but the + and - buttons make very little...