An attempt at it is better than no attempt at doing it at all.
Mach3 should be the base line of achievement / performance, no?
G95 feed per revolution
22 posts
• Page 3 of 3 • 1, 2, 3
Re: G95 feed per revolution
by Robertspark » Sat Aug 25, 2018 7:10 pm
UCCNC Macro Manual v1.2113 - https://drive.google.com/drive/folders/ ... sp=sharing
- Robertspark
- Posts: 1892
- Joined: Sat Sep 03, 2016 4:27 pm
Re: G95 feed per revolution
by cncdrive » Sat Aug 25, 2018 8:44 pm
As I wrote we can probably make it as good or maybe a bit better than in mach3, but we can't do it totally realtime.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
22 posts
• Page 3 of 3 • 1, 2, 3
Who is online
Users browsing this forum: No registered users and 2 guests