. I ask you a suggestion: I can not assign to any key of the numeric keypad the function of the shift key to get 100% of the jogging. How can it be done? thanks to those who want to answer meShift command
3 posts
• Page 1 of 1
Shift command
by alfre » Mon Aug 20, 2018 8:00 am
Hi giù, I bought Uccnc software with satisfaction . I ask you a suggestion: I can not assign to any key of the numeric keypad the function of the shift key to get 100% of the jogging. How can it be done? thanks to those who want to answer me
. I ask you a suggestion: I can not assign to any key of the numeric keypad the function of the shift key to get 100% of the jogging. How can it be done? thanks to those who want to answer me- alfre
- Posts: 33
- Joined: Thu Dec 15, 2016 11:33 am
- Location: Italy
Re: Shift command
by dezsoe » Wed Aug 22, 2018 7:14 am
You could try KeyTweak to remap one of your numeric pad buttons to act as Shift. Warning: I did not try this version! I only remember that about 10 years ago I used this program and it worked.
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 10 guests