Hi
I am just wondering if UCCNC support driving a xy arm with 2 motors working together as with for example "eleksmaker" https://www.youtube.com/watch?v=DF2ISGJus24
I don´t even know what this mode is called but if there is support, can I also control an rc servo for lifting the pen?
Best regards
Synchronous motor control
3 posts
• Page 1 of 1
Synchronous motor control
by Gadget » Tue Aug 14, 2018 6:04 pm
- Gadget
- Posts: 17
- Joined: Fri Dec 22, 2017 9:54 am
Re: Synchronous motor control
by cncdrive » Tue Aug 14, 2018 8:18 pm
I think it is called core XY drive and if it is that then the UCCNC does not support this.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Synchronous motor control
by Gadget » Tue Aug 14, 2018 8:23 pm
Looks like that might be the name for it. 
Thanks for the reply.
Thanks for the reply.
- Gadget
- Posts: 17
- Joined: Fri Dec 22, 2017 9:54 am
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 23 guests