Hi Vmax549
I have tried the macro and its running and probing at the given points, but I miss getting the probed data in a file.
Surface Probe Wizard
4 posts
• Page 1 of 1
Re: Surface Probe Wizard
by henkul » Fri Aug 03, 2018 2:49 pm
- henkul
- Posts: 3
- Joined: Fri Aug 03, 2018 2:42 pm
Re: Surface Probe Wizard
by cncdrive » Fri Aug 03, 2018 8:39 pm
You have to activate the M40 and then the probed datas will be remembered and with the M41 the datas will be written into file.
- cncdrive
- Site Admin
- Posts: 4985
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Surface Probe Wizard
by henkul » Sat Aug 04, 2018 6:03 pm
The M40 and the M41 was already in the generated Gcode-file. I am running version 1.2042 on a Stepcraft and the 'Probe tab' does not show up. I guess I need to upgrade.
- henkul
- Posts: 3
- Joined: Fri Aug 03, 2018 2:42 pm
Re: Surface Probe Wizard
by henkul » Sat Aug 04, 2018 6:30 pm
The Probe tab in the Tools menu show up when I use the default profile. I found the menu parameters in the Stepcraft profile and changed the values, but I only got an empty file.
- henkul
- Posts: 3
- Joined: Fri Aug 03, 2018 2:42 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests