forum.cncdrive.com

Hi there, I am using Geri's screen 2022 and I have set up a few hot keys to run some of the more used commands, it is easy using the hot keys in the I/O set up screen, but I don't know how to assign a hot key to run the z auto zero command, any information or instructions will be greatly appreciated.
Cheers
Nick

Use the button number, they are listed in the manual.

Thanks Geri, it all works great, I had the button number from the manual, but it was in the hot keys screen where I was going wrong, forgetting to press enter etc. I put it all down to old age and a bit of senility

Cheers
Nick