forum.cncdrive.com

Hi Gerry,

in the "Probing" area you can measure the angle in X and Y direction (see screenshot). Is this also possible for a surface in Z direction?
(sorry, I can't upload my screenshot. I get the message "the board attachement quota has been reached". My picture is about 87 kb.

Here is a link to my screenshot: https://cloud.spiesslab.de/s/bNXBigdCeA5ZFkb

Peter

Not sure what you mean, but I'm pretty sure the answer is no.

What I mean is probing a workpiece not only in X or Y direction to measure an angle. I want to do the same with a surface, for example, and probe in the Z direction.

Peter

Do it won't probe the surface. But the Autoleveller plugin will do that.