forum.cncdrive.com

Hello all,

I'm new to UCCNC + AXBB controller but so far, loving it. I have not found anything I cannot do! However, is there any way to change the default move distances in the jog - step window. I'm finding that 0.001 is pretty useless on my router and that 1mm is often not enough. I would like to change the buttons and functionality to 0.01mm - 0.1mm - 1.0mm - 10.0mm. I have found the buttons / pictures etc but no idea where to find the macros that drive these. Cheers and thanks for your help.

Mirko

The default buttons are hard coded and don't use macros. You can create your own macros and change the button numbers to call them.

H i, Understood and safe to say - thats way outside of my capabilities. Thanks for your reply in any event. Rgds, Mirko