forum.cncdrive.com

Anyone making anything good on their machines to give as Christmas gifts this year? Would be neat to see what any of you are up to for idea sharing purposes.

I got making some big 18" long spoons in maple and cherry (based on a Vectric forum posting https://forum.vectric.com/viewtopic.php?p=209289&sid=bada93be19a7454d836e4dcd19dbccea#p209289), and made some modifications to the files to make a flatted spatula/spoon. The flat spoon winds up getting some work on the belt sander to blend out the chunk left near the pointed corner, as its faster to manually sand it off.

Seemed like a neat gift idea, so I made a bunch... Left the artsy designs in the 'bowls' to the wife, and I marked the rear of the handles for fun with the kids input :





If anyone is interested, I could post VCarve or GCode files. Only two bits used are a 1/4" flat endmill and a 3/16" ball endmill.


regards
Eric

Would very much like your kind offer to post the gcode

johnsattuk wrote:Would very much like your kind offer to post the gcode

Sure thing, I packed both spoons up w/ a short description/readme file. Units are in INCHES, stock is 20x4x.75" blanks. Origin is material surface in the center of the board for both sides.


regards,
Eric

eabrust wrote:Anyone making anything good on their machines to give as Christmas gifts this year? Would be neat to see what any of you are up to for idea sharing purposes.

This is one of my homemade Christmas 2021 gifts.
It is a basic, aluminium, Turner’s Cube which has the family names etc. engraved on the centre cube. This photo was taken after the engraving was complete but before the finish polishing.

Tweakie.

Very nice Tweakie, will keep that on my list for a future project/gift idea.

regards
Eric

HI, could you maybe post the Vcarve file?

Assuming you mean for the spoons, and not Tweakie's cube

Format is VCarve 10.5

regards
Eric

Code for Tweakie's cube would be gratefully accepted, would be able to make a lovely Xmas present for someone

Awesome work! Thanks for sharing!