new try, new video. I hope that this time everything works and the video is retrievable (and visible).
Peter
Re: Milling clamps
Posted: Thu Sep 16, 2021 6:24 pm
by cncdrive
Thank you for the video Peter. I think the best is if you will post your video and a link below the embedded video so then even if the embedded player does not show up for some people and on some devices they can still click on the video to go directly to Youtube to watch it.
Re: Milling clamps
Posted: Thu Sep 16, 2021 8:37 pm
by CADdy
Thank you for your reply. Here is the direct link to the video:
Posted: Thu Sep 16, 2021 3:40 pm