Owl - My First UCCNC job with UCCNC and AXBB-E - Happy user
Posted: Sat Mar 07, 2020 5:51 pmHi,
This is my first UCCNC with AXBB-E after upgrade from Mach3 and LTP basic breakout board
I have to say UCCNC and AXBB-E is much superior from what i was using, surprisely linear movement is much better, i can now run higher accelaration without much shaking, using 500 accelaration and 2000 velocity. Also toolpaths run fastter even with same speed settings compared to Mach3. Worth all the money!
Material: Pinewood, 40mm thick
Here the results of a 3d carving:
Also here's a video of my second job, not complated yet: https://www.youtube.com/watch?v=xwfu0vZ4H7A
Beautiful sexy chips in 4K
This is my first UCCNC with AXBB-E after upgrade from Mach3 and LTP basic breakout board
I have to say UCCNC and AXBB-E is much superior from what i was using, surprisely linear movement is much better, i can now run higher accelaration without much shaking, using 500 accelaration and 2000 velocity. Also toolpaths run fastter even with same speed settings compared to Mach3. Worth all the money!
Material: Pinewood, 40mm thick
Here the results of a 3d carving:
Also here's a video of my second job, not complated yet: https://www.youtube.com/watch?v=xwfu0vZ4H7A
Beautiful sexy chips in 4K
