My Machine now with UCCNC
Posted: Sun Apr 01, 2018 2:45 pmNow using UCCNC, very good first impression!
I enhanced my Hobby DIY Machine with a new Controller, Based on the UC300ETH Board on the UB1 Motherboard.
For Details on the Machine check out http://www.masdrive.ch/myprojects/?page_id=381
The New Controller here: http://www.masdrive.ch/myprojects/?page_id=502
some UCCNC Impressions from a Part milling with a spiral morph strategy (forces all 3 Axes to move Simultan)
http://www.masdrive.ch/myprojects/?attachment_id=561
http://www.masdrive.ch/myprojects/?attachment_id=560
I enhanced my Hobby DIY Machine with a new Controller, Based on the UC300ETH Board on the UB1 Motherboard.
For Details on the Machine check out http://www.masdrive.ch/myprojects/?page_id=381
The New Controller here: http://www.masdrive.ch/myprojects/?page_id=502
some UCCNC Impressions from a Part milling with a spiral morph strategy (forces all 3 Axes to move Simultan)
http://www.masdrive.ch/myprojects/?attachment_id=561
http://www.masdrive.ch/myprojects/?attachment_id=560