Page 1 of 1

programming dg4s

PostPosted: Thu Jan 04, 2018 9:10 pm
by paul mcgee
struggling to progamme dg4s with programming stick, sevo configerator3 conected to the first servo driver and i was able to down load pid settings, but it does not see the other sevo drivers when i try to conect and tune those, if i revert bact to the first servo driver it still conects to this, can you sugest were i am going wrong, thanks

Re: programming dg4s

PostPosted: Fri Jan 05, 2018 9:11 am
by paul mcgee
realise what that the problem is now,