Page 1 of 1
Dead at startup.
Posted:
Mon Nov 06, 2017 6:25 pmby Sorendk
Hello absolutly new to Uc cnc. I have installed the program and added lisence key, but when i start the program it dies.. it does not not start up the right way and it is not in demo mode. What can be the problem.
Re: Dead at startup.
Posted:
Mon Nov 06, 2017 8:36 pmby dezsoe
Could you explain what do you mean by "it dies"? Maybe, could you make screenshot(s)? What version with what controller? I'll try to help you if I see your problem.
Re: Dead at startup.
Posted:
Mon Nov 06, 2017 8:40 pmby ger21
And what version of Windows are you using?
Re: Dead at startup.
Posted:
Mon Nov 06, 2017 8:49 pmby Sorendk
I can only install it in demo mode. Now i have tryed to reinstall it and insert the lisene key but i does not detektor it. Before it did detektor it but then it “died” stall after start up, mening it just shows blank screen. I use Uc 100 on a Windows 7 64 bit pc. 128 gb Samsung ssd and 4 gb ram. 2.4 GHz semi old machine but every thing Else is running ok ?
Re: Dead at startup.
Posted:
Mon Nov 06, 2017 9:48 pmby dezsoe
OK. You can only install in demo mode, that is normal. Does it start normally in demo mode? Can you see "UC100 CNC Motion Controller" in Windows device manager? If you run UCCNC\Util\UCxxx_utility.exe and press Scan button, does it show your UC100? (Exit UCCNC before you start UCxxx_utility!)