Page 1 of 1
Y homing actual speed (act. feed) differ from setting
Posted:
Sat Aug 26, 2017 3:56 pmby merrick
On 1.2042, I have the homing speed for long axis (Y) set at 120 (ipm) but I'm seing the feed rate DRO displaying 167. Is that normal?
Re: Y homing actual speed (act. feed) differ from setting
Posted:
Sun Aug 27, 2017 7:12 amby cncdrive
There are 2 homing speeds per axis, one for the upwards movement to the home switch and one is the downwards movement.
Verify that you comparing to the proper value.
Re: Y homing actual speed (act. feed) differ from setting
Posted:
Sun Aug 27, 2017 5:45 pmby merrick
My Y axis has a slave (A). The homing forward speed set for both (Y and A) is 120. Upon executing the homing routine, the DRO indicate that the actual homing speed is 169.1. There was no F override at all.
Re: Y homing actual speed (act. feed) differ from setting
Posted:
Sun Aug 27, 2017 7:13 pmby ger21
I think it's a bug, and the DRO is displaying the blended speed, as if the X and Y were homing together.
At least the math for that adds up.