forum.cncdrive.com

Hi, first question. Profile fails to be created saying profile text field is empty and yet whatever I put in the text field gives the same error. I am importing a mach3 xml and trying to create a profile so I can load this whilst learning how to set up the default profile. looked in the manual and its not a lot of help.

Can anyone help please?

Tony

You have to press the Enter keyboard key to validate the input in DROs.
You can disable this behavior of the UCCNC on the Diagnostics/Appearance tab page and untick the Validate textfields with enter key only option and then Apply and/or Save the settings.

Ah, thank you. I now seem to remember this from somewhere but getting old means the memory is not as good as it was. Thanks again for your help.

Kind Regards

Tony