forum.cncdrive.com

Is there any plans on adding G68.2 and G68.3 transform plane?

Thanks
Mark

Honestly I do not know what G68.2 and G68.3 and do, so I will need to look it up.
But because I do not know what they are I don't think we have any plans yet to implement them otherwise I would already know what they are.

https://www.linkedin.com/pulse/fanuc-g682-5-axis-tilted-work-planes-tim-markoski

complex.... head hurts now...

The reason for asking about the G68.2 and 68.3 is based on the programming software we use to program our Hurco VMX30Ui 5 axis machine. We use Worknc software. I built a 5 axis trunion table that mounts on my Bridgeport and runs on UCCNC. I was hoping to use the same post processor to program both machines.
Thanks
Mark