hello
can we use software like lightburn with the AXBB-E card and control the laser connected to the dedicated terminal 17 with mach3 without having to go through the plugin
++
gilles
laser et mach3
2 posts
• Page 1 of 1
Re: laser et mach3
by cncdrive » Mon Jan 27, 2025 8:20 pm
No you can't unless if the authors of Lightburn has somekind of interface which we don't know about.
- cncdrive
- Site Admin
- Posts: 5054
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 22 guests