Axbb-E. With UCCNC probe issue
Posted: Sat Nov 09, 2024 9:22 amHello,
I have an issue with probe ( simple probe mode) with the only Z axis.
On diag mode, the probe works. I use simple sheet metal 5 mm thick and two cables + and -.
When I click « probe » the Z move up one time 2mm and quickly After few mm. The same result when he detect metal during probe I think.
But the Z axis never go down for detect the plate . Something looks revered somewhere But I don’t know.
Even if I set a minus value in axis 1 P1…
Strange
I have an issue with probe ( simple probe mode) with the only Z axis.
On diag mode, the probe works. I use simple sheet metal 5 mm thick and two cables + and -.
When I click « probe » the Z move up one time 2mm and quickly After few mm. The same result when he detect metal during probe I think.
But the Z axis never go down for detect the plate . Something looks revered somewhere But I don’t know.
Even if I set a minus value in axis 1 P1…
Strange