forum.cncdrive.com

Is there a reason UCCNC has to close when there is a Ethernet loss to the controller. I recently was experiencing intermittent Ethernet problems, very brief losses. With UCCNC closing it just seemed like the program was crashing. It was a hard problem to diagnose because every restart Ethernet was fine. A Estop with a Communication error message box would be a easy indicator of the problem.

UCCNC is built like that, if it looses the connection with the motion controller then it closes the application after asking to save datas.

Thanks for the reply,
If the machine has been homed with nothing else done . As soon as Ethernet link is lost, it closes without a prompt. Unless you're looking for a problem just gives the impression of a crash.