forum.cncdrive.com

Posted: **Wed Jun 12, 2024 9:35 am**

I am trying to use this relay module to connect the COM and FWD together on my Nowforever VFD. Have I understood the wiring correctly in connecting the relay to AXBB E

Posted: **Wed Jun 12, 2024 6:50 pm**

Yes, the wiring looks fine.

Posted: **Thu Jun 13, 2024 1:53 pm**

cncdrive wrote:Yes, the wiring looks fine.

Thanks for confirming, i got the spindle working, hurray. The relay trigger jumper had to be set to Low, it was set to high.
Im not sure why that fixed it, but it did

Posted: **Thu Jun 13, 2024 7:16 pm**

That is because the Isolated outputs are N-channel mosfets (NPN), so they pull the signal low when the output is activated.

forum.cncdrive.com

Connecting AXBBE & Relay Module that uses a Signal Trigger

Connecting AXBBE & Relay Module that uses a Signal Trigger

Re: Connecting AXBBE & Relay Module that uses a Signal Trigg

Re: Connecting AXBBE & Relay Module that uses a Signal Trigg

Re: Connecting AXBBE & Relay Module that uses a Signal Trigg