forum.cncdrive.com

After being a user for some years standing, I lost my control software due to a computer crash. Having purchased a new licence and configured the new software it fails on two counts: the first is that it will only open up in demo mode, the second, is the reset button will not stop flashing with a banner saying a limit switch is active or an e stop button is pressed. This is happening in demo mode with the control box disconnected, (also with control box active). Any thoughts on this? I’ve configured the control using photographs taken from the previous setup in case of future malfunction, the setup had worked perfectly.

You need to get the license working first, so it's not in demo mode. Did you copy the license file into your UCCNC folder?