forum.cncdrive.com

Hi. I am using a UC400ETH and I just updated to the software version in the title. I am trying to install Ger21 2017 screenshot and the first thing to do was create a new profile. On the profiles screen, when I give it a name in the textfield and hit the create New Profile button, I get an error pop-up message that says "The profile name textfield is empty. The profile was not created." Is this a bug? Or am I doing something incorrectly?

It's probably because you not pressing enter keyboard key in the DRO and the Validate textfields with enter key only checkbox is checked on the Configuration/Appearance page.
If that is checked then the DROs new value validates only when you pressing the enter key.
If you leave the DRO not with an Enter key, but for example with clicking somewhere on the screen (e.g. on the create new profile button) then the new value will not validate and the old value will be written back to the DRO which value is on startup is an empty string in the new profile DRO.

So, you can disable that setting or press the enter keyboard key after entering the profile name.

Yes, that was the problem. I feel so stupid.
Thanks for the help.