forum.cncdrive.com

Hi All

Is it possible to save the probe settings between sessions. Stuff like slow and fast probe speed etc.

I have to set them every time I re-start UCCNC.

Thanks

Barry

If you have to set them every time then you use an old version of UCCNC (older than 1.2114) and you switch profiles. Do not do this: start UCCNC with the profile that you want to use. See: how to create shortcut.

You are correct, I start uccnc and the switch it to my profile for my machine. I will start up using the profile I want to use and see what that does.

Thanks !!!