forum.cncdrive.com

Wrong Probing direction

Hi, I'm learning how to use the Probing screen functions.
When I start the Touch probe or Mobile probe operation, the Z axis starts to move upwards.
When I touch the blade with the probe block, the "procedure" happens upwards.
In other machine functions, the movement direction of Z is correct.
How could the direction of movement be reversed?

Best regards, VAMAKA

Details :
Software 1.2113
Firmware 1.0370
Device type UC300EHT- 5LPT

You have to set negative P1 value to move the Z down.