forum.cncdrive.com

Hi looking for some help here.
I have a custom built cnc that has been running perfect for over 2 years. Yesterday for some strange reason i can not move the cnc with the pc controls. It still moves with the wireless pendant but no longer with the pc, as far as i know i haven't changed anything in uccnc as I don't mess about with the settings. they have been set the same since i had the machine. Anyone has an idea what could be wrong?

Check the jog % speed on the flyout screen.

please see image attached. tried it upto 50% still wont jog. can only move with the wirless controller

Num Lock not activated?

the picture you uploaded is too small to see.
on the flyout jog screen.

it must be set to continuous for keyboard to be effective.

mickecarlsson wrote:Num Lock not activated?

That sorted it thanks for the info had no idea this was needed to jog the machine from the pc

Battwell wrote:the picture you uploaded is too small to see.
on the flyout jog screen.

it must be set to continuous for keyboard to be effective.

Thankyou. setting to Continuous sorted out the problem in UCCNC