forum.cncdrive.com

Can anyone help me with a license file issue ? I was just about to try out the new lathe software but am getting the error "no valid license file found"
I have been using the UC100 for 5 years or more running Mach3 with no problems, but now I am getting this error. I can't remember if I ever had a license file or not to run Mach3 !

I have searched my PC for a license and all I can find is a license file for my mill, which is running with a UC300 5LPT. If I need to purchase a license, then so be it, so could someone tell me how to go about it ?

If this is for Mach3, their should be a file called Mach1lic or something similar, in your C:\Mach3 folder.

ger21 wrote:If this is for Mach3, their should be a file called Mach1lic or something similar, in your C:\Mach3 folder.

No it's not for Mach3 Gerry, I was hoping to try out the new UCCNC Turn function on the lathe. I'm going to assume my Mach3 license won't work for that.

Yes, the Mach3 license is for Mach3 with or without any UC device. You'll need a UCCNC license for your UC100. You can buy it at CNCdrive or you local distributor.

Is there a problem with the license? I paid for on Monday but still nothings arrived! Sorry if I'm being impatient, keen to try this out.

Sorry for the delay.
I just sent you the license key in email yesterday.