Cycle stop acting as reset
Posted: Tue Oct 03, 2023 6:24 amHi All, hope you are well.
I am having a crazy issue - I've set up a machine on the default plasma screenset version 1.2113.
I do not have any keyboard mappings, I am using the onscreen controls - when pressing "cycle stop" in the middle of a rapid or toolpath the machine will stop suddenly without decelerating(As if the reset was pressed or a limit was hit).
I am not doing anything funky, all the default macros are in place - this is just a normal setup.
Any ideas on what I can try?
Thanks in advance!
I am having a crazy issue - I've set up a machine on the default plasma screenset version 1.2113.
I do not have any keyboard mappings, I am using the onscreen controls - when pressing "cycle stop" in the middle of a rapid or toolpath the machine will stop suddenly without decelerating(As if the reset was pressed or a limit was hit).
I am not doing anything funky, all the default macros are in place - this is just a normal setup.
Any ideas on what I can try?
Thanks in advance!