Page 1 of 1

g28 and write offset on homing

PostPosted: Wed Sep 20, 2023 7:33 am
by asuratman
If I use g28, when I cycle start, the endmill will drag on the top of fixture. To avoid this, I have to set Z axis Write Offset on Homing to 25 for example. Is there any other way to avoid dragging on surface fixture ?

Re: g28 and write offset on homing

PostPosted: Thu Sep 21, 2023 2:17 am
by asuratman
Sorry, I found the answer from autodesk forum ...