Page 1 of 1
I have a problem with the reset
Posted:
Mon Feb 27, 2017 4:49 pmby JHP03
Everytime I start UCCnC the reset button keeps on blinking even in overide limits. the X Y Z limits led are lit in the Diagnostics page and the estop. Also the X Y Z A home led are lit to
Re: I have a problem with the reset
Posted:
Mon Feb 27, 2017 10:08 pmby cncdrive
If you can't remove the reset condition then your e-stop input is active. You can't override the e-stop button, only the limit switches with the limit override.
You can check the e-stop input state on the Diagnostics page.
The home LEDs are lit if you homed the machine.
Re: I have a problem with the reset
Posted:
Tue Feb 28, 2017 3:21 pmby JHP03
I unpressed the e stop button but i would still give me the reset problem. I tried override limits but still it wouldn't work.
Re: I have a problem with the reset
Posted:
Tue Feb 28, 2017 5:09 pmby cncdrive
Please post a printscreen of the UCCNC with your Diagnostics screen is selected when you can't remove the reset condition.