spindelmotor
Posted: Fri Sep 01, 2023 11:25 amIs there a drawing on connecting spindle motor with a frequency converter to the UC300 ETH ?
Tommy Ollevik
Tommy Ollevik
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
spindelmotor
Page 1 of 1
Posted: Fri Sep 01, 2023 11:25 amRe: spindelmotor
Posted: Sat Sep 02, 2023 6:06 pmIt's going to depend on what breakout board(s) you are using.
Re: spindelmotor
Posted: Mon Sep 04, 2023 8:20 amUC 300 ETH board