Is there a drawing on connecting spindle motor with a frequency converter to the UC300 ETH ?
Tommy Ollevik
spindelmotor
3 posts
• Page 1 of 1
Re: spindelmotor
by ger21 » Sat Sep 02, 2023 6:06 pm
It's going to depend on what breakout board(s) you are using.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 15 guests