Laser Diode Wiring to UB1 Board - UC300ETH + UCCNC
Posted: Thu Jul 20, 2023 2:52 amHello everyone,
I have a UB1 - UC300ETH board to which I would like to connect a Chinese laser diode (Laser tree LT-80W-AA PRO). The laser came with a driver adapter (P-DA-01) which, as far as I understand, has two outputs: GND and TTL-PWD. I'm not very knowledgeable about electronics, so I kindly ask for your help in wiring the laser to the UB1 board and how to properly configure it in UCCNC.
Currently, I have the spindle connected and it works perfectly. My question is whether it's possible to connect both devices without having to disconnect the other. Is this possible?
I would greatly appreciate your assistance.
Thank you all and best regards!
I have a UB1 - UC300ETH board to which I would like to connect a Chinese laser diode (Laser tree LT-80W-AA PRO). The laser came with a driver adapter (P-DA-01) which, as far as I understand, has two outputs: GND and TTL-PWD. I'm not very knowledgeable about electronics, so I kindly ask for your help in wiring the laser to the UB1 board and how to properly configure it in UCCNC.
Currently, I have the spindle connected and it works perfectly. My question is whether it's possible to connect both devices without having to disconnect the other. Is this possible?
I would greatly appreciate your assistance.
Thank you all and best regards!