UC300 0-10V issue
Posted: Mon Jun 12, 2023 7:46 amHi All
I have gotten RPM speed control working successfully in the past, but on this particular setup I have an annoying issue.
The 0-10V output fluctuates when moving an axis.
I have the correct GND and AI pins on the UC300 motion controller as per the manual as well as the correct settings in UCCNC - everything works apart from this issue.
Any Ideas on what I could be missing?
Thanks
I have gotten RPM speed control working successfully in the past, but on this particular setup I have an annoying issue.
The 0-10V output fluctuates when moving an axis.
I have the correct GND and AI pins on the UC300 motion controller as per the manual as well as the correct settings in UCCNC - everything works apart from this issue.
Any Ideas on what I could be missing?
Thanks