forum.cncdrive.com

Hoping someone might be able to help,

Have everything wired up and have a relay triggering the VFD To start, which works but for some reason the 0-10V goes to 10v as soon as i start CW Spindle. IE 24,000RPM

When i change the speed, the VFD drops to the requested rpm and then speeds back up to max RPM.

Any Idea what ive done wrong here?

Cheers Brad

Make sure to disable the spindle PID controller. You can find a button on the spindle settings page and it opens a setup window and there is a checkbox to enable the spindle PID control. Disable that.