charge pump on.
Posted: Wed Feb 08, 2023 10:50 ami need a solid on signal. not pwm which follows the charge pump
always on when uccnc is in control.
method?
always on when uccnc is in control.
method?
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
charge pump on.
Page 1 of 1
Posted: Wed Feb 08, 2023 10:50 amRe: charge pump on.
Posted: Wed Feb 08, 2023 10:13 pmCan you slave a output trigger so when the charge pump output is on then output # is on as well ?
Re: charge pump on.
Posted: Thu Feb 09, 2023 12:36 pmwas just wondering if its going to act as pwm instead of solid output. or if it will detect as off in the loop.