Unable to activate the reset
Posted: Sat Feb 11, 2017 4:30 pmHello my Name is Ian
I’ve been using a UC100 with the UCCNC software on a System 45 controller from DIYCNC for quite a while now, I’ve been quite happy with the setup until recently the Z-Axis intermittently ignores the code and hence just ploughs through the job, but that’s another story!!!
I’ve now been building my own controller setup with:
UCCNC software
UC100
Benezan Mini BOB, inc. RJ45 adapters
4x Leadshine DM556 Drivers
No limit switches (for the moment)
Now my problem is I’ve been over everything and I can’t trigger the reset button, charge pump is working according to the BOB, but on the UCCNC diagnostic screen the LED is flickering.
Anyone have an idea, please.
Regards
Ian
I’ve been using a UC100 with the UCCNC software on a System 45 controller from DIYCNC for quite a while now, I’ve been quite happy with the setup until recently the Z-Axis intermittently ignores the code and hence just ploughs through the job, but that’s another story!!!
I’ve now been building my own controller setup with:
UCCNC software
UC100
Benezan Mini BOB, inc. RJ45 adapters
4x Leadshine DM556 Drivers
No limit switches (for the moment)
Now my problem is I’ve been over everything and I can’t trigger the reset button, charge pump is working according to the BOB, but on the UCCNC diagnostic screen the LED is flickering.
Anyone have an idea, please.
Regards
Ian
- Reset Error
- Setup