forum.cncdrive.com

Hard Drive went out,
Put in new hard drive, Loaded my UCCNC Software into new Drive,
Copied and pasted my license for AXBB-E controller into the UCCNC Folder. Still opening in Demo,
Uninstalled Software, and Reinstalled, Same thing, Demo mode,
Need a new License or how to get the one I have to work,
Thanks very much,
Dale

Check your network configuration with the UCxxx_utility. (See AXBB manual for details.)

Yes I figured it out, Forgot You had to set up the network again,
Now trying to get motors all tuned in again,
Z-Axis is giving me hell,
Thanks for your input though,
I knew it had to be something simple,,
Cubs