Simple touch probe setup + AXBBe
Posted: Sat May 21, 2022 11:50 pmHi guys,
I have been trying to setup a simple touch probe much like what is shown in this youtube video. I bought the same style probe, but removed the led and resistor, and added a single wire.
From my understanding (and on from another thread on this site), I should connect the 24+v wire to the I3+ terminal, then the probe wire to I3- on the axbbe. Is this correct? Or do i need to add a -24v wire from my 24v power supply to the workpiece (either permanently or only when probing).
I wasn't sure if connecting the 24v- to my machine vice was safe to do or if it would cause issues elsewhere?
https://youtu.be/cR0ipN44Gn0
I have been trying to setup a simple touch probe much like what is shown in this youtube video. I bought the same style probe, but removed the led and resistor, and added a single wire.
From my understanding (and on from another thread on this site), I should connect the 24+v wire to the I3+ terminal, then the probe wire to I3- on the axbbe. Is this correct? Or do i need to add a -24v wire from my 24v power supply to the workpiece (either permanently or only when probing).
I wasn't sure if connecting the 24v- to my machine vice was safe to do or if it would cause issues elsewhere?
https://youtu.be/cR0ipN44Gn0