UCCNC and Super-PID
Posted: Fri Sep 09, 2016 1:45 amHas anyone set up a Super-PID router controller in UCCNC?
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
UCCNC and Super-PID
Page 1 of 1
Posted: Fri Sep 09, 2016 1:45 amRe: UCCNC and Super-PID
Posted: Fri Jan 06, 2017 12:05 amIts been a long time sense you asked this . I got my setup working if interested.
Re: UCCNC and Super-PID
Posted: Wed Apr 05, 2017 4:33 pmHello Charlie,
I just noticed your response. I would be interested in your experience with your Super-PID and UCCNC. Was it easy to integrate into your system? Is it working well? Any photos available?
thanks,
Jim
I just noticed your response. I would be interested in your experience with your Super-PID and UCCNC. Was it easy to integrate into your system? Is it working well? Any photos available?
thanks,
Jim
Re: UCCNC and Super-PID
Posted: Wed Aug 23, 2017 12:30 pmI'd be interested in how you got yours setup.
I just got my UC300ETH and am in the process of calibrating the machine, but the spindle keeps running. Can't shut it off.
Dale
I just got my UC300ETH and am in the process of calibrating the machine, but the spindle keeps running. Can't shut it off.
Dale