forum.cncdrive.com

hi, I decided to connect my spindle motor driver with 0-10v signal I use UC300ETH-5LPT and a UCBB, now two questions:
can I use analog channel 1?
and for the return of the encoder A B and INDEX can I use 3 inputs on the UCBB connecting A + A- to the first input B + B- to the second and Z + Z- to the third?
I am attaching a schematic of my driver.

Thank you

Yes, you can use analog channel 1. of hte UC300ETH-5LPT for the spindle 0-10V reference control voltage.
Yes, you can connect the differential lines to the UCBB inputs.
The last page of the UCBB users manual describes how to connect differential lines like the outputs of your device: http://cncdrive.com/downloads/UCBB_manual.pdf

ok, thanks