Rigid Tapping
Posted: Thu Jan 20, 2022 8:14 amhi, i wanted to know if i can use rigid tapping with Uccnc?
right now i'm using the spindle motor with an analog output 1 and 2 outs for forward / reverse.
my spindle driver is set up and has a pin for enabling rigid tapping and expects an analog signal + 10-10 (UCCNC is not possible) or a step/dir signal,
also do I have to also connect the encoder output from spindle to controller?
Thanks in advance for your advice, but that's something I've never done
right now i'm using the spindle motor with an analog output 1 and 2 outs for forward / reverse.
my spindle driver is set up and has a pin for enabling rigid tapping and expects an analog signal + 10-10 (UCCNC is not possible) or a step/dir signal,
also do I have to also connect the encoder output from spindle to controller?
Thanks in advance for your advice, but that's something I've never done