forum.cncdrive.com

New here - have the XYZ steppers wired and operating. My question is on the AXBB-E Port 2 inputs for limits.
In UCCNC Axis setup it asks for PIN Number for Limit + and -, and Home Pin.

On the AXBB-E I see I1+ and i1- on up to i6

What are the pin numbers for these?

Thanks

Michael

It depends on to which input pin numbers you connected your limit and home switches, you set those numbers according to your connections.

On the AXBB-E I see I1+ and i1- on up to i6

What are the pin numbers for these?

1-6