forum.cncdrive.com

UCCNC machine control software support forum
https://forum.cncdrive.com/

AXBB Port 3

https://forum.cncdrive.com/viewtopic.php?f=4&t=3369

Page 1 of 1

AXBB Port 3

PostPosted: Thu Aug 19, 2021 12:26 pm
by johnsattuk
Is it OK to use ports for step/dir/enable outputs

Re: AXBB Port 3

PostPosted: Thu Aug 19, 2021 1:41 pm
by cncdrive
Yes.

Re: AXBB Port 3

PostPosted: Thu Aug 19, 2021 2:08 pm
by johnsattuk
Thanks :D
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/