forum.cncdrive.com

Hello

I just installed my UCCNC and now am setting it up to work with my MPCNC machine. I am frustrated trying to save configuration settings. If I calibrate the Axes it will save the calibrated units per step but if I change any other nubers on that screen and hit Apply or Save the numbers immediately change the values back to what they were. I have tried running the program with Admin privileges, turning off the antivirus program, Copying the profile and everything but it still will not save my setting. What am I missing?

Hit the ENTER key after entering numbers.

There's also a setting on the Appearance tab to disable the ENTER key requirement.

OK, thanks! The enter key was not working but when I unchecked the setting to "Validate textfields with with Enter Key only" then the save button works fine.