5 axis offset
Posted: Tue Apr 13, 2021 10:53 pmHello, I am using UCCNC since a couple of year with my 3 axis mill, but now I am covering it to 5 axis and I have a doubt about the offset.
With 5 axis it is very difficult to align the workpiece with the same origin of coordinates used in the CAM, so some controllers (industrial grades) have options like the Dynamic Work Offset or the Tool Center Point Control to recalculate the pattern from the gcode once the misalignment has been measured.
Does UCCNC have anything similar?
With 5 axis it is very difficult to align the workpiece with the same origin of coordinates used in the CAM, so some controllers (industrial grades) have options like the Dynamic Work Offset or the Tool Center Point Control to recalculate the pattern from the gcode once the misalignment has been measured.
Does UCCNC have anything similar?